As this involves power input, kindly ensure that you're performing the steps on the right device to prevent power failure or any hardware issue. Please refer datasheet for all feature and specification.
This article aims to guide you on how to properly connect the DC power cables and successfully turn on the device safely.
This article targets only SKY-8132S-11 models.
All users with SKY-8132S-11 who have experience on DC power and voltage.
Step1: Get 48V DC power input.
Step2: Device will boot and you can hear FAN in maximum speed for awhile then down.
Step3: Power LEDs light up in the middle of DC connectors.
Step4: Connect console and set baud rate in 115200, 8, n, 1.
- Note: console cable shall be standard version, pin definition as below.
Step5: You shall find the console output on your console utility.
--- End ---
Article is closed for comments.