Introduction (CVE-2019-6260, nickname pantsdown)
The ASPEED ast2400 and ast2500 Baseband Management Controller (BMC) hardware and firmware implement Advanced High-performance Bus (AHB) bridges, which allow arbitrary read and write access to the BMC's physical address space from the host (or from the network in unusual cases where the BMC console uart is attached to a serial concentrator). This CVE applies to the specific cases of iLPC2AHB bridge Pt I, iLPC2AHB bridge Pt II, PCIe VGA P2A bridge, DMA from/to arbitrary BMC memory via X-DMA, UART-based SoC Debug interface, LPC2AHB bridge, PCIe BMC P2A bridge, and Watchdog setup.
The problem may be seen:
Users may see the only cursor flashing after the Windows OS logo popping up during the OS installation.
Installation Procedures:
- Install the OS with the OS default driver (Standard VGA)
- Download the driver (>=1.10 version) from the Aspeed website
- Boot into the Windows and install the corresponding driver.
Note: Basically support Windows 7 / Windows 10 / Windows Server 2012 / Windows Server 2016 / Windows Server 2019, please refer to the "ReadMe.txt' for more details.
Comments
0 comments
Please sign in to leave a comment.